How To Specify Kwik-File's 4-Post Shelving
Shelves
Shelves are formed of 22ga. cold rolled steel with flanges on
four sides. Front and back flanges are turned in to form a .75"
channel. Shelves are slotted on 3" centers for adjustable file
support dividers. Shelves are supported by 11ga. steel shelf
supports running the full width of the shelf. Shelf reinforcements
are provided and run the depth of shelves over 24" deep. 6"
high file supports dividers can be provided. Removable center
stops and backstops are provided for use with the file supports
dividers. Dust covers canopy tops are available for all shelving
sections.
Uprights
Open "T" uprights consist of two 1.5" wide 18ga. cold rolled
steel posts rolled into a "T" formation with taper-lock slots
on the inner face at 1.5" on center. There are no holes on any
exposed face. There are three 3" 18ga. stringers welded between
posts to form an upright. Closed "T" uprights consist of a 20ga.
steel panel welded between posts to form uprights. Closed "L"
uprights consist of a seamless 20ga. panel formed around and
welded to and "L" 18ga. slotted post. Uprights provide a seamless
end appearance for shelving without additional end panel.
Specifications
/ Ordering Steps for 4-post when used on 810 Manual or 820 Mechanical
Assist
|
